LoginSignup
Starin Logo
Active Thermal Management Dealer Portal
 
- Last Change/Effective Date: 01/28/2016

  Pricing Downloads: Long PDF Version Short PDF Version CSV Excel / Ezip PDF List Only
 
Availability subject to change without notice; consult your representative if needed.
Pricing is subject to change without notice. Notification to individuals in your organization is available by requesting weekly updates.
All pricing in US Dollars.
Click on model numbers for more info
 
Results per page:
Page Number:  of 3


Coolers - Equipment Coolers
Equipment Coolers are designed to cool a single piece of gear. These devices are ideal for situations where you need to enhance limited ventilation.
Model Description Pricing
01-008-01
Dual Mode Component Cooler

• Designed to boost existing (but insufficient) ventilation for audio and video components
• Can be configured for use above or below a component depending on where the vent openings are located
• Fans operate continuously at an idle speed, switching to a higher, but very quiet, speed, controlled by a thermally-activated switch
[more]
 
List: $230.00
01-002-02
Cool-It II

• Ideal for amps, receivers and almost anything else that could overheat in your system
• Easy to install; just center the unit above the heat sinks and plug the power supply into an AC outlet (cool air quietly flows down and between the heat sink fins lowering the temperature to more tolerable levels)
• Controlled by a thermal switch (fully automatic)
[more]
 
List: $144.00
01-008-03
Cool-Slim
 
List: $245.00
 
Coolers - Enclosure Coolers
Enclosure Coolers are designed to be used in closed cabinets, sealed areas, and other non-ventilated spaces.
Model Description Pricing
03-401-01
Cool-view Electronic Thermometer
 
List: $65.00
00-301-03
Cool-Stack I EXHAUST

• Exhausts heated air from the top of a sealed rack (with air opening at the base of the rack)
• 1RU high cooler suitable for moderate heat loads
• Include 90°thermal switch or can accept a 12 volt trigger signal
[more]
 
List: $335.00
00-302-02
Cool-Stack I INTAKE

• Intakes cool air from the bottom of a sealed rack
• 1RU high intake suitable for moderate to large heat loads
• Include 90°thermal switch or can accept a 12 volt trigger signal
[more]
 
List: $335.00
00-303-01
Cool-Stack II

• 2RU high cooler suitable for moderate to high heat loads
• Heated air can be exhausted through the front, top, or rear panels
• Multi-speed operation; speeds set by remote dual temperature switch assembly
[more]
 
List: $550.00
03-303-03
Cool-stack II rear exhaust kit
 
List: $50.00
03-303-04
Cool-stack II top exhaust kit
 
List: $50.00
00-304-01
Cool-stack III

• 1RU hot air exhaust system for mid-size racks with mid-size heat loads
• Four 120mm fans and an 18" depth pull 70 CFM of hot air out of tightly packed racks
• Heated air is exhausted through the perforated front panel, but exhaust fittings and tubing provided can move the hot air safely away to the rear if the rack is located in a closet or cabinet
[more]
 
List: $450.00
00-202-03
Quad Cool
 
List: $400.00
00-305-01
Dual Cool
 
List: $445.00
03-402-01
Dual Cool Optional wall mount bracket
 
List: $22.00
00-306-01
Cool Rack- NEW!!
 
List: $349.00
00-100-02
System 1

• Very quiet system for cooling large rack or shelf-mounted installations as well as the largest 3-chip DLP video projectors that have been enclosed for noise control or aesthetics
• Comprised of a very powerful inline centrifugal fan with a precisely-balanced rotor for minimum vibration, and acoustically-muffled tubing large enough to allow a large airflow at low velocity, minimizing noise
• A "hot air collector" is included (transition fitting that simplifies connecting the tubing to an opening in any flat surface, such as the back of a cabinet, or the ceiling of a closet)
 
List: $559.00
00-100-03
System 1 EXT (Weatherproof)

• Very quiet system for cooling large rack or shelf-mounted installations as well as the largest 3-chip DLP video projectors that have been enclosed for noise control or aesthetics
• Comprised of a very powerful inline centrifugal fan with a precisely-balanced rotor for minimum vibration, and acoustically-muffled tubing large enough to allow a large airflow at low velocity, minimizing noise
• A "hot air collector" is included (transition fitting that simplifies connecting the tubing to an opening in any flat surface, such as the back of a cabinet, or the ceiling of a closet)
[more]
 
List: $624.00
00-100-06
System 1 6"
 
List: $679.00
00-100-08
System 1 8"
 
List: $769.00
00-100-E6
System 1 6" EXT (special order)
 
List: Call
00-100-E8
System 1 8" EXT (special order)
 
List: Call
00-200-02
System 2 (2 Fans All-in-One Panel)

• "All-in-one" system with 2-fans and controller are mounted on a gasketed panel (approx 14"w x 5.5"h)
• Mount in the back panel of the enclosure
• Two thermal sensors are clipped to whatever generates the most heat in the enclosure and adjust the fan speeds automatically
 
List: $314.00
00-201-02
System 2 Kit (2-Fans, Free Placement)

• Similar to the System 2, but the (2) fans are not mounted to a panel
• Gives installer the ability to mount the fans in the best possible location in a particular installation
 
List: $299.00
00-202-02
System 2+2 Kit (4 Fans, Free Placement)

• Similar to the System 2, but the (4) fans are not mounted to a panel
• Gives installer the ability to mount the fans in the best possible location in a particular installation
 
List: $389.00
00-203-01
System 2 Rack-Mount (3 Fan Rack Mount)

• Designed to cool the small to mid-size rack
• Small thermistor senses temperature rise, and adjusts fan speed accordingly
• Effective mounting technique: install the System 2 Rack Mount on the rear rails of a rack, as high as possible & a 1U vent panel, as open as possible, low on the front rails of the rack
[more]
 
List: $329.00
00-400-01
System 3 (2 Small Fans)

• Small, thermally-activated ventilation system for smaller installations
• Ideal for the bedroom audio system tucked into a nightstand or the CPU in a kitchen cabinet
• Ideal for use within a larger enclosure, where pockets of heated air must be dispersed
[more]
 
List: $129.00
00-401-01
SEC-1

• Used in exhaust mode, mounted to the rear panel of a small enclosure at least 2" from a wall
• Two 80 mm fans are pre-assembled to a thin panel which mounts over a simple rectangular cutout on a small cabinet's back panel.
• Thermal switch assembly that fastens magnetically to the component whose temperature is being monitored
[more]
 
List: $135.00
00-602-00
System 4 NO GRILLE
 
List: $275.00
00-602-NA
System 4 w/ Natural (silver) aluminum
 
List: $325.00
00-602-BA
System 4 w/ Black aluminum
 
List: $325.00
00-602-WO
System 4 w/ Wooden grille (White Oak)
 
List: $349.00
00-602-CH
System 4 w/ Wooden grille (Cherry)
 
List: $349.00
00-602-MA
System 4 w/ Wooden grille (Maple)
 
List: $349.00
00-602-BW
System 4 w/ Wooden grille (Black Walnut)
 
List: $349.00
00-602-PG
System 4 w/ Wooden grille, Paint Grade
 
List: $349.00
12-013-WO
System 4 wooden grille ONLY (White Oak)
 
List: $50.00
12-013-CH
System 4 wooden grille ONLY (Cherry)
 
List: $50.00
12-013-MA
System 4 wooden grille ONLY (Maple)
 
List: $50.00
12-013-BW
System 4 wooden grille ONLY (Black Walnut)
 
List: $50.00
12-013-PG
System 4 wooden grille ONLY, Paint Grade
 
List: $50.00
10-108-NA
System 4 Alum grille ONLY (silver or black)
 
List: $45.00
10-108-BA
System 4 Alum grille ONLY (silver or black)
 
List: $45.00
00-701-01
Cool Stick 36"

• Developed for ventilating flat panel displays that have been recessed into walls
• Sixteen 50mm fans wired in 2 groups provide a high level of airflow and 100% redundancy
• Each fan group has its own power supply and thermal switch; any failure results in at least 50% of airflow being maintained
[more]
 
List: $359.00
00-701-18
Cool Stick 18"

• Developed for ventilating flat panel displays that have been recessed into walls
• Sixteen 50mm fans wired in 2 groups provide a high level of airflow and 100% redundancy
• Each fan group has its own power supply and thermal switch; any failure results in at least 50% of airflow being maintained
[more]
 
List: $205.00
00-502-BW
Cool-Vent II (4x80mm fans, Black Walnut)

• Can be configured to quietly move air in or out of an enclosure
• Dual thermal switch, turning on at 90 degrees and switching to a higher speed at 100 degrees
• Easily seperate into fan & grile sections for ease in staining as needed
[more]
 
List: $349.00
00-502-CH
Cool-Vent II (4x80mm fans, Cherry)

• Can be configured to quietly move air in or out of an enclosure
• Dual thermal switch, turning on at 90 degrees and switching to a higher speed at 100 degrees
• Easily seperate into fan & grile sections for ease in staining as needed
[more]
 
List: $349.00
00-502-MA
Cool-Vent II (4x80mm fans, Maple)

• Can be configured to quietly move air in or out of an enclosure
• Dual thermal switch, turning on at 90 degrees and switching to a higher speed at 100 degrees
• Easily seperate into fan & grile sections for ease in staining as needed
[more]
 
List: $349.00
00-502-PG
Cool-vent II Paint Grade
 
List: $349.00
00-502-WO
Cool-Vent II (4x80mm fans, White Oak)

• Can be configured to quietly move air in or out of an enclosure
• Dual thermal switch, turning on at 90 degrees and switching to a higher speed at 100 degrees
• Easily seperate into fan & grile sections for ease in staining as needed
[more]
 
List: $349.00
00-503-BW
Cool-Vent III (2x120mm fans, Black Walnut)

• Can be configured to quietly move air in or out of an enclosure
• Dual thermal switch, turning on at 90 degrees and switching to a higher speed at 100 degrees
• Easily seperate into fan & grile sections for ease in staining as needed
[more]
 
List: $369.00
00-503-CH
Cool-Vent III (2x120mm fans, Cherry)

• Can be configured to quietly move air in or out of an enclosure
• Dual thermal switch, turning on at 90 degrees and switching to a higher speed at 100 degrees
• Easily seperate into fan & grile sections for ease in staining as needed
[more]
 
List: $369.00

Number of items per page: 50
Page Number:  of 3

 
 
Starin • 136 Venturi Drive • Chesterton, IN 46304 • Fax (219) 929-4377 • Customer Service: csr@starin.biz
© 1999 - 2017 Starin Marketing, Inc. All rights reserved.
 
If you have any ideas or new content for this or any Starin portal, feel free to send it to coolportalideas@starin.biz